How to uninstall fca Videos

+Luxan Rogue I don't remember any noise from an FCA anytime that I have been checking one both then again I rarely have issues with one. Its a good possibility that there could be an issue with it. I assume its operation would be about the same as what I work on when compared to your PX8.

+Brian Lau Hey Brian.....the best way I have seen to check the FCA is viewing the data with a scanner and seeing what the fuel pressure sensor is reading when it happens. Usually needs around 5000 psi before it will start. Any leak in the fuel system with external or internal can cause a low pressure and no start. Also making sure to check the lift pump flow is the starting point I recommend. Further testing will require some special tools and fittings to test flow and also to block off injectors if need be. I rough way to check the lift pump flow is to find the line going from the fuel filter housing to the high pressure pump and unhook it from the high pressure pump. You need to catch the fuel that comes out into a container. You then need to bump the key to the start position and leave the key in the run position. This will cause the lift pump to run for about 10 seconds. Then you need to measure how much fuel was collected in the container. We need to measure milliliters so you need to get you a measuring cup from somewhere like the kitchen department at Walmart.

+Brian Lau WD -40 did not work for me