Mitsubishi electric freedom pa Videos

• 1. Mitsubishi Electric Power
• 2. Mitsubishi PA 10-7C Human-Robot Interaction
• 3. Gridtie Solar System Final: Balance of System, Part One
• 4. Natural Gas and Electricity In PA & MD - Shipley Energy
• 5. Mitsubishi PA 10-7C - Embodied Cognition
• 6. Robot Mitsubishi - movement in all degrees of freedom
• 7. Five Finger Death Punch-Wrong Side of Heaven 25/11
• 8. NYC - Electric Bike Hits Car
• 9. Robot Mitsubishi - preberanie podstavca

Mitsubishi Electric Power

Mitsubishi PA 10-7C Human-Robot Interaction

User Comments

christian ventez abadia commented on 23 Jul 2015

I am a student from the Javeriana University in colombia, we have a mitsubishi PA-10A Arm wich i want to use to move it using the kinect device but the card used is installed in a windows NT PC and i can't find any documentation...do you have any visual c++ 6 programming guide for the robot arm, any tutorial?

xerocorp commented on 11 Nov 2009

a very good film, i enjoyed it very much. the direct useful application of robots in everyday life was immediately obvious. brilliant.

Gridtie Solar System Final: Balance of System, Part One

User Comments

SolarSteveUSA commented on 07 Jun 2012

In a grid interactive system there are no batteries. It is a direct utility intertie inverter that produces as many 240V AC amps as the PV array will allow. This allows the array to make more power overall compared the the average battery based system in a maintenance charging profile (exceptions exists here of course). Because of maximum power point tracking, the inverter is able to regulate itself as PV input changes to provide the highest possible amps output.

IKE GERARDy commented on 06 Jun 2012

Hi Steve, I,ve being told that you always need a battery bank to get a proper domestic distribution of power through the household due to the flunctaion of the solar energy to the solar panel when connectted directly to an inverter.. pls is this the case and did you use batteries in your own project aswel. cheers.

SolarSteveUSA commented on 25 Aug 2010

@dealsaua....The sealant used is Sikaflex 291 marine adhesive/sealant. I ordered it online from Jamestown Distributers. The stuff is amazing! One could probably use in automotive applications, as in gasket bedding, as well. Thanks for watching!

SolarSteveUSA commented on 07 Jun 2012

Remember, this is NOT an off grid system. When PV/inverter output is less than the actual real time load from the residence, the grid makes up the difference. When the opposite is true, the utility meter effectively runs backward.

SolarSteveUSA commented on 07 Jun 2012

The down side with this type of system is that any utility interruption will also interrupt the inverter as a safety measure. In that case, a true off grid system really shines as the presence of grid power is not required.

SolarSteveUSA commented on 23 Mar 2010

@Stime64....All inter-panel wiring and panel to inverter wiring was done with 10ga USE-2, stranded. Inverter to sub-panel wiring with 10ga THHN, stranded. Thanks for watching!

IKE GERARDy commented on 13 Jun 2012

I wa also curious about the grid suffering a power loss for example, will that effect your Energy supply being produced from your solar inverter grid to your household.

SolarSteveUSA commented on 07 Jun 2012

I hear ya on batteries, they aren't created equal and are expensive for quality. That being said, this system is grid interactive which means batteries aren't required.

dealsaua commented on 25 Aug 2010

Hi, thx for the vid...what's the sealer called? I googled seakaflex but don't thing that that's the right spelling. Thx in advance for your help.

SolarSteveUSA commented on 16 Nov 2010

@depravedpuma...Ultimately the grounding does terminate at the ground rod as you'd normally see in residential electrical.

Stime sixtyfour commented on 23 Mar 2010

Hi I was wondering if I may ask you what gauge wire you are using to go from your panels to your inverter? Thanks Stime

depravedpuma commented on 15 Nov 2010

Steve when you ground the panels to each other are they grounded to a rod driven into the groung?

Mohamad Khalil Hamieh commented on 13 Apr 2012

nice work ,the only mistake i did in my system i bought non good battery's .

SolarSteveUSA commented on 16 Nov 2010

@depravedpuma...Ultimately the grounding does terminate at the ground rod.

SolarSteveUSA commented on 07 Jun 2012

seka is the brand. I used sekaflex 291

Natural Gas and Electricity In PA & MD - Shipley Energy

Mitsubishi PA 10-7C - Embodied Cognition

Robot Mitsubishi - movement in all degrees of freedom

Five Finger Death Punch-Wrong Side of Heaven 25/11

NYC - Electric Bike Hits Car

User Comments

U.SCarCrashTv commented on 25 Jan 2016

Do you mind if I use this for a U.S car crash compilation video? Will put links to your video in the description of the video.

M5827 commented on 25 Jan 2016

+U.SCarCrashTv Please do! I don't mind at all.

Robot Mitsubishi - preberanie podstavca