Audi 2.5 tdi breather Videos

• 1. VW Golf MK3 Estate Variant Tdi AHU 1997 oil breather leaking - after cleaning
• 2. Vw t4 oil breather worn rings
• 3. VW TOUAREG MOTOR 2.5 TDI **BAC** 174 PS bj.06 ENGINE MOTEUR MOTORE
• 4. VW Transporter 2.5tdi ACV(2002) rattle in pulley area.
• 5. Fixed my breather vent hose
• 6. USP Motorsports VW MK6 Jetta 2.5L Cold Air Intake System
• 7. 1.4 mpi skoda fabia rattle(2)

VW Golf MK3 Estate Variant Tdi AHU 1997 oil breather leaking - after cleaning

User Comments

WindyJAMiller commented on 05 May 2011

@weazlechin Sure is a crap bit of plastic, seems that the engine before and engine after both dont have this bottom breather. the solution is a blanking plate from a Mk2 1.8 petrol engine see 'Show more' for a link to the solution. Cost me £18 in parts but the job is done and will neve leak again. Thanks for the comment

Vw t4 oil breather worn rings

VW TOUAREG MOTOR 2.5 TDI **BAC** 174 PS bj.06 ENGINE MOTEUR MOTORE

VW Transporter 2.5tdi ACV(2002) rattle in pulley area.

User Comments

Graham Jones commented on 07 Jan 2014

I think it's your alternator tensioner? The belts make a lot of noise when the tension is slack. Not east to change might be worth a new belt and try and free up.

Tomasz Burzyk commented on 07 Jan 2015

hi. are you sorted this? have the same with my T4 ACV

Thomas EXOVCDS commented on 09 Jun 2013

Hi, was the balancer bad?

Fixed my breather vent hose

USP Motorsports VW MK6 Jetta 2.5L Cold Air Intake System

User Comments

E Hernandez commented on 08 Jan 2016

Will this fit in a 2013 jetta 2.5 with an automatic transmission?

caseygawriluk commented on 08 Jan 2016

Yes

Cristian Ortega commented on 04 Jan 2016

how do you install or where can you get it installed??

caseygawriluk commented on 16 Jan 2016

very straightforward. Just had to relocate the power steering pump reservoir and transmission computer. Everything else just bolts right up

Cristian Ortega commented on 15 Jan 2016

+caseygawriluk how hard was it to install?

caseygawriluk commented on 04 Jan 2016

Local shop or dealer. Ordered this from USP. Check the description

Andres Natalino commented on 03 Aug 2015

would this work on a passat 2.5 2012?

caseygawriluk commented on 15 Aug 2015

+Andres Natalino pretty sure it would

KingOf Ny commented on 12 Jul 2015

Just got my '12 Se... been trying to find and intake system for this, but that's another story. lol! Any ideas of where to look? I do not want to have make my own. And their is no way where I would be able to just put a Conie on the hose?

caseygawriluk commented on 17 Jul 2015

+KingOf Ny USP Motorsports

Dinger182 commented on 26 Jan 2015

Is this just the intake? Cuz it sounds like u got an exhaust too

caseygawriluk commented on 26 Jan 2015

At this time. Yes it was just the intake. The car is now paired with an AWE Track Catback and a USP Test Pipe. Haven't had time to finish the video with the test pipe but I do have another video of the catback exhaust

Dungeons Dragons commented on 14 Nov 2014

on dyno tests cold air intakes are junk the suck heat air from the engine heat kills power if you you buy one your looking at a 5 to 6 hp loss tests on dyno prove this

BCH37501 commented on 02 May 2015

Where can I find the data on this test? More specifically, this car? The intake placement in this case seems logical as it's not just sitting in the hot bay, but down by the wheel well where cool air flows. 

Dungeons Dragons commented on 02 May 2015

The tests were done by pro who build cars.

BCH37501 commented on 01 May 2015

+Dungeons Dragons That's on some intakes, now if it was a SRI I could see your argument. This intake is actually designed to be sucking in cold air and is located properly.

1.4 mpi skoda fabia rattle(2)