Club car kohler engine Videos

where do you get the cluch for that engine, i need one. but i cant seem to find one

Not hating on your video, but you didn't address the most important issue with these carbs. You really should replace the brass throttle shaft bushing while you have it out. This will make the rebuild a little more tricky but it is MORE IMPORTANT than people think. Get the bushing, new screws, and new throttle shaft. The screws like to break so just grind off the heads with a dremel tool and cut shaft. Put in new shaft, use new screws, with locktite in old throttle plate. Then rebuild rest of carb! That area is a wear point that can leak a lot of dirty air around shaft causing a lean fuel condition, hotter running engine, burnt valves, and #1 cause of warped heads! Don't think yours (reader) needs this done? Put your mouth over top of carb. and blow, you might be surprised. 

Was it four turns out per screw?