Mr2 spyder lightweight flywheel Videos

Cannon 50D. Alot of compression from youtube though. 

+InATrance4Life I'm running a GT3071 at 24psi with no BOV (I have a few videos up). As noted earlier, as long as you aren't surging on boost you'll be fine.

+TwinTurboEffect nice thanks for info I will give it a try when I get my gen 3 running soon

+InATrance4Life Prime has set up many like this with no negative effects, some are set up at higher boost levels too. On throttle compressor surge is bad. Running without a bov or bpv decreases lag on gear changes if you shift quick. Some have deleted it on gen2 and gen3 and say the turbo is much more responsive.

+Yod S It is awesome, in first week i had it i never shifted above 4k and it felt similar to gen2. Turbo does spool quicker though, i feel it around 2k. But around 4500 the gen2 does not compare, i get pushed further into my seat and the car pulls hard. You can see it around 36 seconds of the video, caught me by surprise the first time i held the gear to redline.No serious issues, had a noisy clutch release bearing but it has calmed down and i talked to Justin who assured it was fine. And i had to tighten the clamps on the intercooler couplers a bit more cause of a small leak. Prime Performance is great, you won't regret it.

Not running a bov

+Subielove4ev It came out to 6,000 something. All depends on the condition of your mr2 and if you want to add upgrades to it. You should send them an email, Justin will take care of any questions, they are very customer oriented.