i think i can mack one of thes and sens i can,t post it on here. So first.
This is how just bild up stiky piston ,s half way up then bild up to blok,s
plase a buton on the top block behind it plase one bloke on the ground
.then plase red stone on the block you just plast then plase red stone on
the ground then plase red stone on the ground . So it go,s in front of your
elavator . Then wen it,s akrost were you plase one. Block.then plase one
one block. Hire then turn it so it still.go,s around
I appreciate you Bringing this to my attention, HOWEVER this isnt the same
type of elevator. That link is to a piston elevator. this is a Piston
Powered Car Elevator. there are others that use sand and pistons for a
"Car" like elevator but this is the only elevator that acts like a real
life elevator in which you ride inside a "Car" to the top floor. So this is
still the FIRST Piston CAR elevator on Minecraft Xbox 360. which is
arguably the best most impressive/reliable elevator on xbox.
If you guys didnt know there is a tutorial alread made I made multiple
floorrs on this elevatore and im going to load up a video in a few days if
you want to know what it looks like just type in multiple floor car piston
elevator
It, s sweet and look around case I think I'll be able to make one of e, m
and if you want visit my land named oz and I'm usely on at three o clock
and I'm on the x box and you can rent a hous and I'm making rekit ralf land
you can just make sure not to run the redstone into any of the elevator
blocks to avoid issues with the elevator operation or add a delay and time
it as your actual up/down buttons instead of manual buttons
Send me a link to the video you are referencing and if its an actual Piston
CAR elevator ill change the Title. before i uploaded i searched alot and
couldnt find one.
This is not the first, another was made on JULY 22 2012. This was made in
AUGUST 21 2012... but this would still be the best one that no one has said
it wasnt te best
you could make this which could take you hours of collecting resources and
building or you could get some wood and make a ladder howwever this is much
cooler
+SebTheGamer yeah there is a bit of a flaw so far where you cannot attach both ends of things at the same time. The devs has hinted of a welder tool fix so hopefully that happens soon
Looked like the reason it went was because all the weight was going to the
attached piston and shifted to the front of the vehicle. If you could clamp
the platform to the point of connections (especially on the side of the
ramp), it'd probably work with the car. :D.
+Dahl Dantill Gaming Until then, can you put a piece around that 'clamps' the back end? Just something that will go around from your pistons and prevent the platform from bending away from those pistons?
+Darth Koonstyle Yeah. Hope they bring out a way of attaching to other things like a welder of sorts
KORUWORKS LLC S13 with Fortune Auto Air Piston Lift System (APLS) installed
This video shows the Koruworks S13 with the Fortune Auto Air Piston Lift System installed.
Really Compact 6x7 Car Piston Elevator Tutorial!!
This video will be a tutorial on a really compact car piston elevator I already showcased in another video, alongside a 2x2 car lift, so check that out!! Sorry if this is ...
To test the down circuit I had to set both repeaters to 4 ticks delay to
get it to work, but for the up circuit I can't get it to work at all. With
7 ticks of delay between pulses (instead of the 6 you suggest) the up
circuit begins to work but comes to rest with the bottom piston only having
been pulled up by two blocks. Does this design still work for you in
1.7.2? If so I'm for sure doing something wrong and I don't know what
because I've checked, checked, and re-checked my work...
look up the power function from the mk8 (original car elevator) pulse limiter with a single repeat clock 6 between pulses on a 3tick pulse. but if it starts and fails a couple blocks up im certain there is a repeater out of timing very close to where its failing
Minecraft: 3 Tiny Piston Elevators!
Get notified of all my latest uploads: //goo.gl/Jv8i1o Hey guys! Today I am going to be showing you how to build a few small piston elevator designs, they are ...
2:00 I don't think it needs to be that complicated. There's a simpler
solution. Just put down a slime block surrounded by 4 obsidian (2 in the
wall) in the corner of your house with a piston under it, then on the 2
non-wall sides of the piston put down 2 redstone, and then on top of the
obsidian blocks above the redstone put down some pressure plates. No
repeaters needed.