Enter your query, example: how not cry when slicing onion or how to enter an Free Italian Sex Webcams?
2000 jeep cherokee oil drain plug size Videos
4L80E Transmission drain plug install
To make maintenance a little easier I installed a drain plug in the oil pan. Thanks for watching!
User Comments
jackson j
commented
on 15 Sep 2014
why not put the nut from inside the pan?
Sound Insect
commented
on 21 Jun 2015
+jackson j It's better to have a flat surface inside the pan so the fluid can freely drain. One the fluid level was low enough, it would block a small amount from being able to drain.
drew a
commented
on 28 Nov 2014
possible clearance issues
anesthesiadreamin
commented
on 26 Jun 2014
Thanks to your video I'm now going to do this on my 68RFE (Ram Cummins
transmission). Pans are thin, what ga wire did you use? Also, I see you are
sometimes pushing and sometimes pulling, which would work best to prevent
burnthrough? thx again, excellent video
Matthias zehentbauer
commented
on 07 Feb 2015
+Broncocarl92 pushing is the"right" way to weld with MIG. its makes the weld colder aswell. when welding thin steel you should consider using TIG or getting someone professional to TIGweld it for you. if you concentrate the heat to much towards the nut you wont get a very strong weld on the tin side, witch can make it crack and leake even if its leakeproof just after welding due to the frequent heating and cooling of the oilpan over time :) just a little tip:)
Broncocarl92
commented
on 28 Jun 2014
My machine has .030 wire in it.. I never gave it much thought about the pushing and pulling, but I try to concentrate the heat on the nut not the tin.Thanks for watching.
Sign up for free
to join this conversation on fsaved.com.
Already have an account? Sign in to comment
Already have an account? Sign in to comment